Magellan Paradox Manual de Instalação descarregar pdf (Página 11)

Paradox Magellan Systems 11

Location and Mounting

Location

The locations of Magellan and its wireless transmitters affect

the overall performance of the wireless system. To ensure

the best signal reception, the following list of location criteria

should be respected whenever possible:

• Select an installation site that is free of obstacles that

reflect and absorb radio frequency (RF) signals, as well

as interference that may distort signals. Avoid

installation near or in the path of strong RF fields (i.e.

neon lights, computers), and on or near metal objects,

circuit breakers boxes, air conditioners and heater ducts

since they may cause interference and reduce the

console’s sensitivity.

• Select a site that is not susceptible to drastic

temperature changes.

• Mount the Magellan console as central as possible to the

proposed placement of the wireless transmitters.

• Mount the Magellan console as high as possible.

• Avoid installing Magellan in the basement as the range

of the console is reduced when installed below ground

level. However, if it is absolutely necessary to install the

console in the basement, install the console as high as

possible and as close to the underside of the first floor as

possible.

• Install the Magellan console on a wall allowing at least

5cm (2”) around the console to permit adequate

ventilation and heat dissipation.

The Wall Plate

Magellan uses a plastic wall plate to stay mounted on a wall.

The wall plate is also used for tabletop mounting to cover

the back of the console as well as keep any wires within

their respective wire slots. After choosing an appropriate

location (see Location on page 11), mount the wall plate

onto the Magellan console as described in Mounting

Magellan on the Wall or Tabletop Mounting below. The

Magellan console is then secured to the wall plate through

two screws.

Figure 9: Wall Plate

Figure 10: Mounting Magellan onto the Wall Plate

Figure 11: Magellan’s Back Plate

Mounting Magellan on the Wall

After mounting the wall plate (see The Wall Plate), the

Magellan console can be mounted as shown in above. To

do so:

1. Place the wall plate on the desired spot of the wall.

2. Drill and insert screws into holes labeled A as shown in

Figure 9 on page 11.

3. Place the console back plate flush against the mounted

wall plate.

4. Slide the Magellan’s open slots labeled D (see Figure 11

on page 11) onto the wall plate’s tabs labeled B (see

Figure 10 on page 11).

5. Gently apply downward pressure to insert the wall

plate’s tabs into Magellan’s open slots.

6. Insert two screws through the wall plate’s screw holes

labeled C and into holes labeled E (see Figure 10 on

page 11) in the Magellan back plate. This will secure the

console to the wall.

Tabletop Mounting

Magellan can also be mounted on a tabletop. This is a

useful convenience that allows Magellan to be situated on a

nightstand, desk, coffee table, etc. Included with Magellan

are two plastic feet as well as two rubber stops. The plastic

feet raise the Magellan console to a slight angle for easy

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 44 45

Comentários a estes Manuais

Sem comentários

Magellan Paradox Manual de Instalação Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Magellan Paradox